GO-1020MG (0.08 s/60°, 7.5 kg.cm)

SKU: 377484
GTIN: 8596450022270
HAN: KAV20.1020MG
Category: reaktivieren
Manufacturers: Kavan

46,90 €

incl. 19% VAT , plus

Goods ordered. 4 piece expected on 28.01.2026.
Delivery time: 4 - 6 Workdays (DE - int. shipments may differ)

piece

Description:

Powerful and fast programmable digital micro servo with a robust metal gear train and dual ball-bearing output shaft, designed for use in all types of RC models. Thanks to its flat 12 mm case height, it is especially well suited for ailerons and flaps in RC gliders and sailplanes with thinner wing profiles. The servo is housed in an aluminium case which acts as an efficient heatsink, providing excellent cooling and reliable performance even under heavy continuous load.

Using the GO Servo USB programmer/interface and PC software, you can adjust a wide range of servo parameters (travel range, neutral position, overload protection, soft start, fail-safe behaviour and more) so the servo can be perfectly matched to your model and flying or driving style.

Programmable functions:

Travel range: Sets the maximum servo throw. Default approx. 120° in the normal pulse range (900–2100 µs), up to approx. 180° in the extended pulse range (500–2500 µs).
Neutral position: Fine adjustment of the servo centre position.
Damping: Adjusts the servo behaviour when slowing down or stopping its movement.
Output power: Adjusts torque and speed in the range 39.2–100 %. Higher values increase power and speed (with proportionally higher current draw).
Sensitivity: Sets the deadband (insensitive range). Higher sensitivity narrows the deadband so the servo reacts to smaller signal changes. Available levels:
- Ultra High – deadband approx. 1 µs
- High – approx. 2 µs
- Medium – approx. 3 µs
- Low – approx. 4 µs
Soft start: Enables or disables soft-start to prevent abrupt movement at power-on and protect the gear train.
Servo reverse: Reverses the direction of rotation.
FUTABA SR mode: High-speed mode for FUTABA SR channels only (do not use with other FUTABA modes or non-FUTABA systems).
SANWA SSR mode: High-speed mode for SANWA SSR channels only (do not use with other SANWA modes or non-SANWA systems).
Fail-safe: Behaviour in case of signal loss:
- (a) Free – fail-safe off, no active holding.
- (b) Hold – the servo holds the last valid position.
- (c) Go to neutral – the servo moves to the centre position (pulse width 1500 µs).
Overload protection: Three-stage overload protection. If overload persists longer than the preset time (in seconds), the output power is reduced to the preset percentage of maximum power.
Reset: Restores the factory default settings of the connected servo.