Are you looking for ultimate speed? Allow me: the FMS Flash - which not only looks damn fast - it's also!
The Flash is designed to minimize drag in the best possible way and thanks to its aerodynamic shape it chases like a controlled ball through the air. Powered by the built-in 3536-KV1750 brushless motor in combination with the efficient 7x5" pressure propeller, the Flash reaches top speeds of up to 180km/h.
The High Speed model is made entirely of lightweight and extremely robust EPO rigid foam material. The reinforced fuselage and wings provide maximum stiffness at these speeds even under the most extreme conditions. In addition, the foam material can be easily and sustainably repaired with superglue in the event of damage or stains.
In addition, the Flash comes as an almost ready-to-fly PNP model with a built-in motor, 60A regulator and four 9g digital servos with metal gears. The model is ready to fly in about 10 to 30 minutes and can be screwed together and stowed in the compact size in any trunk. Battery in, receiver in, and the flash is ready to put a big grin in your face. A special handle on the underside of the fuselage makes every hand start easy. In addition, the runner protects the airframe during long belly landings.
The Flash is also prepared for the use of FPV equipment to experience speed from the pilot's perspective. An additional and special canopy offers sufficient space for FPV camera, video transmitter and antenna.
Properties:
- Top speeds of up to 180km/h from the box
- reinforced construction made of extra strong EPO rigid foam material
- low weight with maximum stiffness
- Brushless 3536-KV1750 motor and 60A controller built-in
- including 2 pcs. 7x5" propellers
- four 9g digital servos with metal gear built-in
- handle under the fuselage for perfect hand starts
- big canopy allows easy access to electronics
- additional canopy for installation of FPV electronics
- compact size - suitable for every trunk
- fast assembly with screws in approx. 10 to 30 minutes
- Flight time approx. 3 to 5 minutes
- for advanced model pilots
- including richly illustrated and German assembly instructions
Reflex stabilization system (included in this set):
This set includes a Reflex system specially programmed for this aircraft. This electronic stabilisation system was developed to assist the pilot with control commands, but not to disturb them. The Reflex system works with both PPM and SBUS inputs and works natively with all common remote control systems. If the reflex system is assigned to a 3-channel switch, it can be selected between 3 different modes.
Stabilized mode:
When the control knob is released, the model is automatically brought into a neutral flight position, which provides a lot of safety in dangerous situations for beginners and unskilled pilots.
Optimized mode: The gyro system of the reflex system counteracts external influences such as wind or side winds and keeps the model in a stable position.
Off: The Reflex System can be switched off completely.
The Reflex System is specially adjusted for this model aircraft. No further programming is necessary, only the installation and connection in the model has to be done. The Reflex System can be connected to all receivers with at least 4 channels.
Technical Data:
- span: 850 mm
- Length: 890 mm
- Flight weight: approx. 890 g
- area content: 12 dm²
- flat loading: 74 g/dm²
- Motor: Brushless 3536-KV1750
- Controller: Brushless 60A with EC3 plug
- Servos: 4x Digital 9g MG
Scope of delivery:
- Flash PNP
- Reflex stabilization system
- Benötigtes Zubör:
- Remote control: min. 4 channels
- Recipient: min. 4 channels
- Battery: 4S LiPo 2200mAh 35C (EC3)
- LiPo Charger
