The PowerBox Royal SR2 has a newly developed automatic servo matching function. This allows up to three servos to be automatically matched to each other via 5 points in just a few seconds. All you have to do is select the mechanically linked servos and

Item number: 340013

Herstellernummer: 4750

EAN: 4250416704634

Category: PowerBox


599,00 €

including 19% VAT. , plus shipping

Not available now!
piece


The PowerBox Royal SR2 is built into a äußerst compact and noble housing with aluminum Kühlkper. The large cooling fan dissipates the heat from the 4 controllers, which provide the power for all 26 servos in pairs. Both pairs of controllers can be set to 4 different voltages. This allows standard 6V servos to be combined with powerful HV servos without the need for additional controller components.

For the first time, all data of all servos can be monitored in the model and their parameters can be set from the transmitter. This development goes back to the introduction of our P²-BUS protocol, the aim of which has always been to provide complete control of all the components in the model. The PowerBox Royal SR2 has four independent P²-BUS interfaces, which can be set to two different voltage levels.

Servos with integrated P²-BUS, or normal servos with the new P²-ServoBridge, can be connected to these interfaces. The P²-ServoBridge is an adapter that converts the P²-BUS into a PWM signal for normal servos and has a continuously adjustable electronic fuse built in. This allows a bus system to be implemented in the model that is clearly superior to normal PWM wiring in terms of safety and performance.

Uml;ber the color display, all data of the receiver and the power supply are displayed and all settings in the easy to understand, structured and bilingual menü durchgefühhrt.

The TFT display is also built into a high-quality aluminum housing and is easy to read even in full sunlight. In conjunction with the optionally available iGyro SAT, the PowerBox Royal SR2 provides a 12-axis gyro system with unparalleled functionality. Even the most complex models can be set up in just a few minutes using the setup wizard. The gyro sensitivity is then taught in with a setting flight in the air using a rotary encoder. A whole range of additional expert settings then allow the pilot to adjust the gyro effect to his or her own individual requirements.

The gyro sensitivity can be set up in just a few minutes.

A GPS III sensor can also be connected to the PowerBox Royal SR2. This automatically adjusts the gyro sensitivity to the airspeed. The 26 outputs of the PowerBox Royal SR2 are not only adequately supplied with power, they can also be individually assigned various functions.

All outputs can be assigned with direct and gyro channels, or with door sequencer function.

The PowerBox Royal SR2 has a newly developed automatic servo matching function. This allows up to three servos to be automatically matched to each other via 5 points in just a few seconds. All you have to do is select the mechanically linked servos and start the process. Each output can of course also be manually adjusted with the servo matching function in the graphical menu. The system becomes complete with the two integrated door sequencers.

In addition to the landing gear, canopy controls with interlocking can also be implemented without additional devices. The first door sequencer can be taught in within a few minutes with the help of a setup wizard - 3 modes are available. Other special settings can be easily adjusted thanks to the graphic display, which shows the entire time sequence at a glance. For PowerBox and Jeti pilots, the PowerBox Royal SR2 can be operated and adjusted almost completely from the transmitter! Telemetry for battery and receiver data is fully developed for all supported systems. With GPS III connected, GPS data is also available - as far as the respective remote control system supports it.

 

Average product review

Write your first review and help others with their purchase decision:

Contact
Question on item
Contact