Graupner

Graupner - Schaltmodul 10A

SKU: 296787

Category: switches

Manufacturernumber: S8527
GTIN: 8809403498047

11,99 €

incl. 19% VAT , plus

Lager Lieferant

Lieferzeit: Must be ordered. Ready for shipment in 3-6 days after order.

Notify me when this product is available

piece

Lager Lieferant

Lieferzeit: Must be ordered. Ready for shipment in 3-6 days after order.

With the switch module 10 A it is possible to switch a load directly via a receiver output. The receiver output must be programmed for level control (ON/OFF) (from receiver software version V7.XX). An encoder (toggle switch) can be assigned to the switching channel (mc-16 to mc-28 or mx-12 to mx-20, mz-18 and mz-24). For themz-32 and mc-32 (2019 version), digital switches on the touch screen can also be programmed as encoders. Both ON/OFF and BLINKING With the jumper you can distinguish between power supply of the load via receiver (jumper set) or external supply. (Jumper pulled) With external power supply via X3/X4 the jumper MUST be pulled, otherwise the receiver, the components connected to the receiver and the switch module will be damaged ! The consumer ( motor, LED, light bulb etc.) is connected to X1 / X2. No cables are soldered to the board, so there is the possibility for different cable thicknesses and connector types.

The module can be fixed in the model either with double-sided adhesive tape or with cable ties. When mounting, make sure that the board does not bend and that the underside of the board does not touch any other components (risk of short circuit).

After soldering the cables to X1-X4, the enclosed heat shrink tubing is pushed over the board and shrunk with a hot air gun. Separate cable lengths and thicknesses can be used for X1-X4, depending on where the consumer is located.

Technical data: