Robbe Modellsport - Mistral 2.0 Styro/GFK/Abachi PNP - 2000mm

Robbe Modellsport

Robbe Modellsport - Mistral 2.0 Styro/GFK/Abachi PNP - 2000mm

SKU: 334871

Category: speed

Manufacturernumber: 2644
GTIN: 9010189153979

690,19 €

incl. 19% VAT , plus (Sperrgut)

Available immediately
nur 1 Stück lagernd!

Lieferzeit: 1-2 Werktage

piece

Available immediately
nur 1 Stück lagernd!

Lieferzeit: 1-2 Werktage

The V2 version of the Mistral now has a high-strength, Abachi-covered wing. This increases the weight of the Mistral by about 150g compared to its predecessor, which has been tried and tested hundreds of times, but makes it much more robust for everyday use. In flight, the Mistral gets even more power and the typical Hotliner characteristics come into their own. The Mistral is a multi-talent and the absolute fun model for the end of the day! Thanks to the modified RG-15 profile and the built-in Ro-Power BL drive, vertical climbs are possible without any problems and are thus very reminiscent of a hotliner. Of course, the Mistral is not the same as a full GRP Hotliner, but that was not the goal.
The eye-catching and modern neon-coloured hotliner design should help you to easily recognise the model in the sky at all times and distinguish it from other models in the air and on the ground.

Be impressed by the high speed range of the Mistral. A landing with the flaps set is always a pleasure and absolutely stress-free, which is why the model is also suitable for advanced pilots.

The Mistral is ready to fly after just a few simple steps. In addition to the built-in Ro-Power 3522 amplifier, the model also contains six pre-installed, digital Robbe servos with metal gears. The wiring is also ready to go. The prefabricated and pre-mounted linkages only need to be fitted and adjusted accordingly.

Features:

Two-piece styro/GfK/Abachi surface covered with Oracover, with CfK insertion
through-going sandwich spar (carbon-pine-carbon) for maximum bending stiffness
Installed digital Robbe servos with ball bearings and full metal gears
Finished wiring of all servos with MPX 6-pin connectors between wing and fuselage
Finished rudder flaps with mounted rudder horns
painted GRP hull with built-in wooden bulkheads and CfK reinforcements

Large canopy for easy battery replacement

ready hinged rudder

prefabricated rudder linkage with linkage parts made in Germany

Finished cut-out servo shaft and linkage covers

Anodised aluminium spinner with straight centre section

High-strength carbon-fibre 11x8 airscrew

modern, highly visible design

Technical data:

Spanwidth: approx. 2000mm
Flight weight: approx. 1780g
Length: approx. 1170mm

Scope of delivery:

Model Mistral V2 incl. two-part, Oracovered Styro/GfK/Abachi wing
CfK wing panels
painted GRP fuselage with CfK reinforcements
Ro-Power 3522 1000 K/V installed
6x FS 155 BB MG digital servos installed
Carbon folding airscrew 11x8"
Turbo spinner 38mm fitted
Wiring with MPX 6-po. Connectors
Small parts
Assembly instructions in German/English